Project IS300: HKS Drager II Axleback Exhaust Install and Review

We have already been showing your our R32 GTR, and now there is a new car in the RFD Garage.  Yep, the Lexus IS300.  Even better, we found a great condition manual transmission car.  But right away we noticed it was too quiet.  Wayyyy too quiet.  So we had to liven things up a bit.

There are quite a few ways that you can make your car sound more aggressive, and some will actually give you some power gains a well.  For cost and simplicity’s sake, we started with an axleback system.  With our normally aspirated inline-6 however, performance gains are non-existent, or at least not substantial.  Once we start messing with the rest of the exhaust, including the headers, midpipe, etc. that may change.  But for now, we just wanted to make it a bit louder.

Will holds the HKS exhaust

Enter HKS.  The Drager II system is well known and after watching a few YouTube videos, we were pretty sold on the sound.  We sourced ours from TH Motorsports for a very reasonable $355.46 shipped!  Being a 6, it’s not tinny or buzzy, it has a nice deep baritone and if anything is a bit quiet.  In particular, between 2500 – 4000 RPMs it really sings.  But I’m spoiling all the good video content.

So, let’s get to it shall we?  Take a look at our installation video and initial review below.

Total
0
Shares

Let Us Know What You Think

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Previous Post

Drifting a BMW M3 Around the Wet Monticello Motor Club

Next Post

Diagnosing a Mushy Brake Pedal on Our Skyline GTR

Related Posts
Total
0
Share